用于网络分析仪HP 8755 详细指标 pdf文档

AC/DC 10M - 18G 详细指标 pdf文档

详细指标 pdf文档 可用于网络分析仪HP 8755

The 11666A Reflectometer Bridge can make reflection measurements covering from 40MHz to 18GHz. Operation of this type of directional device is based on principles of the resistive Wheatstone Bridge
extended to microwave frequencies. When three bridge arms are 50 ohms, the voltage across corners of  the bridge is directly proportional to the reflection coefficient of the device connected in the fourth  arm. Equivalent directivity is 30 dB to 26 dB. Equivalent output SWR is 1.25 to 1.52. Input SWR is 1.92. Maximum input power is +15 dBm. Quality HP Bridge…dependable and easy-to-use.

5V  0.1-1000MHz
FOR LIN-LOG DEFLECTION AMPLIF

可配合信号源TF2015使用，10MHz - 520MHz

厂 家：英国马可尼

TM9936扫频仪组件

TM9936扫频仪组件

TM9936扫频仪组件

TM9936扫频仪组件

Probe interface assembly for the HP1630 and HP1631 families of logic analyzers

照片2

照片3

可用于HP85064A网络分析仪
The hp11858A Transistor Fixture Adapter adapts the hp11600B and hp11602B transistor fixtures (vertical test port configuration) to the hp85046A S-Parameter test set. The unit uses APC-7 connectors.

The Agilent HP11605A is a refurbished Flexible Arm that mounts on the front of the hp8743B Reflection/Transmission Test Unit and connects to the device under test.Rotary air-lines and rotary joints connect to any two-port geometry. The unit is primarily intended for use with existing hp8743A but can be used with hp8743B. The unit covers the frequency range of dc to 12.4GHz and has an impedance of 50-ohms nominal.

The hp54114A Two-Gigasample/Second Test Set gives the hp54111D digitizing oscilloscope the capabilities of 2-gigasample/second one channel.It also increases bandwidth to 500MHz and rise time to 700 pS.

The 11608A Transistor Fixture provides the capability of completely characterizing strip-line transistors. A through-line microstrip and bolt-in grounding structure, machineable by customer, is included. The unit covers the frequency range dc to 12.4GHz. HP11608A The HP11607A Small Signal Adapter is used with the HP8745A S-Parameter Test Set, permits measurement with HP8410A Network Analyzer incident signal levels, -20 to -40 dBm range 0.11 to 2GHz.

厂 家：国产

数字面板表；数字温度表；数字计时器；

交流、直流指针式电压（电流）表头

详细介绍

照片2   照片3

测量温度范围：-50°C ~ 150°C
Maximum voltage:350V peak
Maximum temperatures:probe tip 150°C
body and cable 70°C

FLUKE-81RF for multimeter
350 VDC MAX;30V RMS MAX

照片

• 10MHz-18GHz
• 14～16dB
• 驻波比 10～30MHz-1.3(0.13); 30～5000MHz-1.15(0.07); 5～18GHz-1.25(0.11)
• 所需电源 28±1Vdc
• 346系列噪声源是与噪声系数测试仪和系统联用的理想噪声信号源。因为它们都具有宽频带（10MHz至18GHz或26.5GHz）特性，故不再需要若干个不同频带的信号源。每个噪声源各自具有特定频率下的校准ENR值，为便于对8970B加载，校准值打印在它的商标上。每个噪声源的低驻波比（SWR）使测量中的主要不确定性因素-测试信号的反身地以减小。此外，备有的各种连接器也减少了对可能导致精度降低的接头适配器的需求。346C的频率覆盖范围最宽，为10MHz到26.5GHz，346B具有高的ENR，低的SWR和各种型式的接头，使之成为一种通用的噪声源。346A是专为精确表征输入阻抗灵敏器件（如GaAs FET和许多UHF放大器）而设计的。该仪器从接通至切断期间反射系数的变化极小器）而设计的。该仪器从接通至切断期间反射系数的变化级小（<.01),因而在测量噪声系数和增益的随输入阻抗变化的关系时可使误差最小。